Originally Posted by
GLTBAV
Need quick tips on configuring wallbox power modules for a bath exhaust fan and two ceiling fans on the same circuit. For the bath exhaust fan, I can set the Load Type to "Motor Switched" under "Supported with Interface" without any additional interface or device, correct? And set the Fixture Wattage to 10 watts based on the fan specs? What about using "Fan Exhaust" under Load Type? For the ceiling fans, not sure what Load Type to use. Do I need a separate device like the HW-RPM-4FSQ-120 and can it run two fans? Thank you for your help!