Upgrading some basement lighting that are currently on a HW-RPM-4R, going to 0-10V dimmable LEDS.
I had read on another post: https://forums.lutron.com/showthread...with-HW-RPM-4R that I could possibly use a TVMKIT with the 4R.
Did a quick mockup and the relay clicks off anytime it goes below 100% (TVM still is dimming just no power to the load). Curious if this still should work and I configured it wrong or just doesn't work with newer versions or something?
Other options are swap to a 4A/4U and use a TVM or go with a LQSE-4T5-120-D. Other than future proofing, are there any significant upgrades to using the DIN Module over the RPM/TVM Kit?
Thanks!