Results 1 to 4 of 4

Thread: Can a GRX-TVMKIT-120 work with HW-RPM-4R

  1. #1
    Junior Member
    Join Date
    Oct 2013
    Posts
    8

    Can a GRX-TVMKIT-120 work with HW-RPM-4R

    I spoke to numerous lutron techs regarding using a 4r RPM with a TVMKIT. Some say 4Rs can be used other disagree. I could use a 4A or 4U of course but with the amperage (8A) of each light I would need to have twelve (12) RPMs. If indeed i can use a 4R how do i put it into the program?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    399
    I have used 4R Just put it in as a 4A The On Off worked fine for me

  3. #3
    Junior Member
    Join Date
    Oct 2013
    Posts
    8
    If I pull 0-10 wire also can i dim the loads?

  4. #4
    Senior Member
    Join Date
    Oct 2013
    Posts
    399
    Yes

    If you don't need to turn off 110 volt to the led driver then an rpm is not even necessary However just because you don't use and rpm module for the Led driver you will still loose the ability to use that rpm zone for anything else For every TVM you install and depending where on the harness you plug it in you will loose the ability to use those 2 zones for anything else other then that specific 0-10 zone I hardly ever need the rpm with todays drivers . Hope this helps don't forget you also have the ability to do dim 0-10 wireles with the rf 0-10 modules

  5. Thanks Blair S. thanked for this post

Similar Threads

  1. What switch to use for dishwasher. Won't work for me.
    By amrogers3 in forum Troubleshooting - CAS
    Replies: 4
    Last Post: 10-08-2016, 12:19 PM
  2. 9.2: Mode Monitoring Does Not Work!
    By veeeh in forum Troubleshooting - RA2
    Replies: 3
    Last Post: 02-11-2016, 08:06 PM
  3. MRF2-3PD work with RA2?
    By Corey in forum General Discussion - RA2
    Replies: 2
    Last Post: 07-07-2015, 03:46 PM
  4. Will HR-REP-120 work with QS?
    By jkvossen in forum General Discussion - HWQS
    Replies: 2
    Last Post: 06-01-2015, 11:01 AM
  5. QS shade work with ESN?
    By malkev in forum Design Assistance - Shades
    Replies: 1
    Last Post: 08-05-2014, 08:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •