I installed my first Caseta switches in April of this year. In my kitchen I have five recessed cans attached to one switch. I replaced my existing switch with a Caseta PD-6WCL switch. I installed EcoSmart 75-Watt Equivalent BR40 Dimmable LED lights (120 VAC, 60 Hz, 140 mA, 12.5 W, 2700K, 940 Lumens 2018GT) into each of the five recessed cans.When I first started using this in April it worked like a charm. I didn't even need to adjust the low- or high-end dimming levels. They faded on slowly to full brightness and they faded off as expected. They also responded promptly when I adjusted the dimming levels using HomeKit, Alexa, and the Lutron app.In June, I started to notice some unexpected behavior. When I turned the lights on by pressing the physical switch on the PD-6WCL the five ceiling lights would do nothing, then flicker on full brightness, then turn off and fade back on to full brightness. This behavior has been consistent since it started. Around the same time it started happening with two other PD-6WCL switches in my kitchen that power a single pair of lights, each (which are also using EcoSmart LED bulbs).I do not notice this behavior with other, less frequently used PD-6WCL switches in my house.I've tried adjusting the low-end of the fade trim up on the lights that are flashing on then turning off. No luck. If I could completely disable the fade on/off functionality on the PD-6WCL I would to workaround this problem, but it looks like it's not possible to change this.Here is the Lutron compatibility report for the EcoSmart bulb closest to the model I'm using. It is for a 65W equivalent version of the EcoSmart R30 (Model 1003012803). I am using the 75W equivalent (Model 1003024002).