Hi everyone,
So I'm currently working on this project where they have 22 DIN devices on link 1 (mainly of 2 types : LQSE-4D and LQSE-4S-10-D).
When I plug the bus on module 19 (LQSE-4S-10-D) everything goes into led cycling mode, I have to remove the link from this device to have the system back on again...
What can cause that ? Is there a way to upgrade/reset/reload a firmware into this module, right now, if I create a bus with only the processor and this module, I can't reach it to perform any kind of activity...