Thanks Thanks:  0
Likes Likes:  0
Results 1 to 6 of 6

Thread: Setting LED backlight

  1. #1
    Junior Member
    Join Date
    Mar 2017
    Posts
    21

    Setting LED backlight

    I'm trying to figure out how to set the LED back light level on switches and keypads. The app-note I found says that you cannot enter APM if a switch has been computer programmed, which they have been. However, in essentials v. 11 I can't see where to set the backlight level?

  2. #2
    Senior Member
    Join Date
    Jun 2013
    Posts
    1,365
    You can adjust the keypad backlight in the design tab. Find the keypad you wish to change --> Edit device. Look for the pull down menu for the backlight. You will need to save and re-transfer.
    Simple automation when DIY isn't working
    intuitivehomecontrols@gmail.com
    fb.me/intuitivehomecontrols

  3. #3
    Junior Member
    Join Date
    Mar 2017
    Posts
    21
    I see that for keypads, but what about switches? The dimming switch manuals say it can be done via APM.

  4. #4
    Senior Member
    Join Date
    Jun 2013
    Posts
    1,365
    Quote Originally Posted by ErikU View Post
    I see that for keypads, but what about switches? The dimming switch manuals say it can be done via APM.

    There is no provision for this in the software. If it is an issue, you might tryu to chnge via the APM, then activate; although I believe the activation will override any changes made in the APM.
    Simple automation when DIY isn't working
    intuitivehomecontrols@gmail.com
    fb.me/intuitivehomecontrols

  5. #5
    Junior Member
    Join Date
    Jun 2017
    Posts
    7
    It would be nice to be able to program the keypad backlight levels via timeclock events.

  6. #6
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    289
    Thank you for taking the time to provide this feedback. I'll make sure that this makes it to our software applications team so they can look into adding this as future feature.

Similar Threads

  1. Setting IP address....
    By atxmudder in forum 3rd-party Integration - CAS
    Replies: 5
    Last Post: 02-01-2018, 02:37 PM
  2. Setting up second main repeater
    By joshg in forum Design Assistance - RA2
    Replies: 2
    Last Post: 11-04-2016, 03:46 PM
  3. STRD keypads backlight not working
    By Imaohw in forum General Discussion - Legacy HW
    Replies: 4
    Last Post: 02-12-2015, 02:11 PM
  4. Pulse CCO Setting
    By vwerke in forum Programming - HWQS
    Replies: 1
    Last Post: 01-15-2014, 03:53 PM
  5. Setting shades to a specific level?
    By thefish in forum Programming - HWQS
    Replies: 2
    Last Post: 10-30-2013, 09:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •