Hello,I have been installing my Caseta system along with many Commercial Electric can retrofit lights that also have a night light ring. See here: https://www.homedepot.com/p/Commerci...4101/306080129 The way these work is when you turn the switch on, the main bright light turns on. Then if you switch the light switch off and back on again, the night light ring turns on. Turn the switch off and on again, and you're back to the main light, and so on. If the light sits off for any amount of time (1+ minutes), it defaults to the main light on the next power on. According to the spec sheet, these are compatible with the Caseta dimmer (P-PKG1W-WH-R): https://images.homedepot-static.com/...cec207e6e7.pdf However I'm having many problems: 1) Sometimes won't turn on at all 2) Will turn on with some in main light mode and some in night light mode (out of sync) 3) Turn on in different order/delayed instead of all on at the same time. 4) I've also had it trip the breaker when turning on. These problems seem to go away if the lights are "warm" as in if they have been sitting there on and in-sync for a little bit. 5) Assuming I can get the above problems fixed, there is another problem. Lets say I want to automatically program the night light to turn on at a certain (time like at night ;-)). This would involve the following schedule: turning the light off (to ensure we start at off), on, off and then back on again. But the minimum interval between these schedules that I can select is 1 minute, and that's too long between on/offs and it won't ever go into night light mode. Can we get the ability to select hour, minute and seconds as a scheduled time instead of just hour and minute? Also, these lights work well in my bathroom including the night light function with the Masetro dimmer. It's just the Caseta that doesn't work.