Looking for some help!
Current Setup:
Control4 System on v2.8.0 (HC800 Director)
(9) QS hardwired Standalone shades
(1) Lutron QSE-CI-NWK device on Firmware v8.60
(1) Lutron back up keypad for raise/lower
via putty I have assigned Integration IDs as following:
Shade panel: "01"
QSE-CI-NWK: "02"
Master Bedroom Shade 1: 03
Master Bedroom Shade 2: 04
Grand Shade 1: 05
Grand Shade 2: 06
Grand Shade 3: 07
Grand Shade 4: 08
Grand Shade 5: 09
Kitchen Shade: 10
Library Shade: 11
-Prior to assigning IDs I factory rest all the shades and keypad. I do not know how to factory reset the shade panel (could not find directions) so this is as was.
-I put static IP on the QSE NWK
-I've installed the Houselogix standalone driver into Control4
-Added the shades drivers and confirmed they are bond in connection to the QSE NWK driver.
-Added the ID to the drivers assigned above
-I've added the ID and password to the QSE-CI-NWK driver within Control4. O2 NWK
-Control4 appears to be communicating with the QSE-NWK as I get feedback in the "lua" tab when setting "debug" to print and log.
-When sending open/close from the driver the shades do not work.
-All shades go open/close from panel and keypad without issues.
I'm guessing I'm missing a key step that is not allowing control. Or the integration IDs need to be a certain way. Thoughts? Ideas? Please help. I have 30 of these I need to integrate! Yikes!