So the manual was not much help. I did add a Phantom Button to the MAIN-REP but I am not able to assign the Open / Close action of Input 1 or Input 2 to the MAIN-REP Phantom Button as the MAIN-REP does not show up when I click on the Input 1, then Open or Close in the Select Input Action to Program.
...
...
I had assumed that you could program the Input 1 to activate the Phantom Button when Input 1 is in either Close or Open state.
...
...
I've also tried adding a Homeowner Keypad but get the same result: the Homeowner Keypad does not show up as a selection when clicking on the Visor receiver Input 1 Open or Close state (Select action to program).