I'm having an issue with the integration of my Control4 system with Radio RA2 Triathlon honeycomb and roller shades. When I command any of the individual shades to close using the Control4 driver/interface, the Lutron system doesn't recognize that the shade as closed (i.e., at 0%). Instead, it still shows the shade at its previous level. This causes issue where my seeTouch keypad LEDs do not recognize the scene as "fully closed" therefore the LED does not light. Also, if I go to use the seeTouch to then open the shades, the first press does not move the shades, but instead first registers that the shades are fully closed and the corresponding seeTouch scene button LED lights up. Then on the second press of the open button, the shades with move.Now this issue is only when I use Control4 sliders/buttons to close the shades fully, if instead I move the shades to 50% or fully open, then the Lutron system correctly recognized the status and shows up properly in the Lutron app as such. So my question is, is this an issue with the Control4 integration/driver? Or an issue with Lutron Main Repeater firmware? I used to use an RTI control system that was integrated with the same Radio RA2 system, and don't remember seeing this issue. Also, lighting control works fine from Control4, so feedback of lighting levels tracks in Lutron system/app when I use sliders in Control4.Any help in this matter would be greatly appreciated.Thanks,Dino