Just had a quick question I was wondering. Right now I have a keypad and it controls various lights. For example, let's say button 3 controls the table chandelier, so I have it set to toggle right now, if I press the button the chandelier comes on, I can raise lower, press the button again and it goes off and that's fine.
Where I'm having a bit of a challenge is when let's say multiple lights are on, or I press button 1 which runs a scene and puts the chandelier at 80%. If I then want the chandelier at 10%, to control it from the keypad I press button 3 which turns the chandelier off, I then I have to press it again to turn it on, and then dim or raise to where I want.
I'm finding that there's many times where I want to tap a button like the chandelier, and then be able to raise or lower it, but not have to turn it off and back on first. The problem of course is when you do want to turn it off I'm not sure how you'd do that if tapping the button only "selected" it. Not sure if that makes sense but just wanted to post to see if there's any suggestions or what people do in these cases. It would be nice if it worked even like:
- If the chandelier is off and you press the button, the chandelier turns on
- If the chandelier is on and you press the button, it just selects the chandelier, allowing you to press raise or lower to change the brightness
- If the chandelier is on and you double press the button, or press and hold it, etc it then turns the light off