-
Connect Bridge Not working with app
We installed a basic Radio RA 2 system and used a connect bridge in the system. Load the app and connect app to bridge and configuration loads, then shows all lights and shades in system but doesnt allow any control of anything.
when loaded it says that 99 lights are on and several shades are open, turn all lights off and it shows they are turning off but they were never on, then using app to turn lights on or off does nothing.
Have deleted and reloaded app as well as rebooted Bridge and still the same.
Any thoughts?
-
Did you identify the bridge in the RadioRA2 software? You'll need to do this under the "Find Main Repeater" screen.
-
Post Thanks / Like - 1 Thanks, 0 Likes
-
Yes Both Main repeaters and Both Aux Repeaters as well as the bridge are all Identified.
went out on Friday to reload the programming and now Im unable to load anything into the system. All previous loads were wireless and no issue, Friday I tried wireless as well as wired with firewalls off, static IP on laptop and was continually getting unable to connect.
Call to Lutron and they said my network was the issue, Everything in the house is working fine, if I run a network scan all Lutron devices show up with no issue, Im able to ping all of them, but a load results in a fail every time.
so need to figure this out now then back to the Bridge issue..which is probably related.
-
OK got it figured out, apparently client relocated one of the network cables and just happened to be the one feeding the 2nd Main repeater.
-
Thanks for the update on the solution.