I have this homeworks job which I just commissioned, initially everything worked ok after deploying my programme on the processor. However a particular area of the the house being controlled by a DPM Phase Adaptive was not working properly, here the pendant which is and independent zone always comes on full blast with any other zone, even when programmed to 0% for any of the scenes, and then 2 weeks later or so, the entire lights in this area went off, with the Hi Temp indicator on the DPM permanently on. I manually isolated power from the DPM through the supply breaker, on restoring power, all the zone lights will come on for a second and go off again, till date. I have isolated power from the DPM for more than 24 hours but to no avail.
presently it appears everything has gone wrong, as two more DPMs on the installation are DEAD, no single LED indicator light comes on now and offcourse no light in the zones.
Also from time to time the keypads freeze and no longer respond to button presses until a hard reset is done on the prosessor (Power off and the on).
Please Help!
Raymond.