Hi, we are new to the forums and fairly new to the Lutron family.We have installed a Control 4 system at a customer site and the blind company installed the shades and provided a RA2 Select Main repeater along with a RA2 Select Aux Repeater. The two work fine together but the issue is the customer has a detached garage and of course the signal does not reach the garage in order to operate the blinds located on the second floor.We contacted Lutron and they said we could add another RA2 Select to the project but that would entail the customer having two separate Lutron accounts (one for each main repeater) or we could instead install a RA2 Main Repeater in the house and then add up to two RA2 Select Main repeaters under that one account which would be preferred to eliminate the need for the customer changing from one account to the next. We can not find any information online on how to go about integrating this. We have the following equipment (RA2 Main Repeater, RA2 Aux Repeater, RA2 Select Main Repeater, RA2 Select Aux Repeater). We have a network cable going from the main house out to the garage so we can put the secondary RA2 Select Main Repeater on the same local network in the garage.How would we go about programming this? There are 12 shades in the main house and there are 4 shades in the garage so this is a small system, we just are not sure how to go about integrating both of these RA2 devices together.Thanks for any guidance.