Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: extract project

  1. #1
    Junior Member
    Join Date
    Nov 2014
    Posts
    3

    extract project

    I can't extract radiora 2 project. I am running 8.0 software. Repeater is static, directly connected to PC and repeater version is 7.7.0
    PC sees the repeater however, I get a message "Exception has been thrown by the target of an invocation" and I also get [869]: There was a problem creating a DBprovider with the following parameters: StoredProcedureName:

    Any help would be appreciated.

    Shane

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    403
    Are you getting this error when attempting to perform the extraction or when you attempt to open the project file that was extracted?

  3. #3
    Junior Member
    Join Date
    Jan 2014
    Posts
    14
    I had the same problem. Match the RA2 software with the repeater version and it should work. If you use the old resi.lutron/radiora2 site, you should still have access to the old software revisions. I had to do this recently to extract the programming from a repeater with 7.7 on it.

Similar Threads

  1. Cannot Extract File
    By Kevinmac in forum Troubleshooting - RA2
    Replies: 4
    Last Post: 05-08-2014, 01:12 PM
  2. Project file Extraction and Baud Rate
    By Armando B. in forum Troubleshooting - Legacy HW
    Replies: 1
    Last Post: 03-25-2014, 02:01 PM
  3. Extract XML from Repeater not working
    By rdgerken in forum Troubleshooting - RA2
    Replies: 4
    Last Post: 12-11-2013, 10:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •