Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Initial Cycle Dim Direction on RF Keypads

  1. #1
    Junior Member
    Join Date
    Dec 2013
    Posts
    5

    Initial Cycle Dim Direction on RF Keypads

    Currently, on RF keypads, you are only able to start a cycle dim with a raise and not a lower. Even though the software says you have control over this, you don't. According to tech support RF keypads can ONLY raise as their first direction; this makes the homeowner have to press and hold, release, and press and hold again to get the lights to dim. Lutron, is there any plan to change this? It is especially confusing for clients who are used to the old way and have now upgraded and are using retro-fit RF QS stations now. Thanks.

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513
    Thank you for this feedback. This will be changed in a future release of the RF keypads and they will be able to be configured from the software to start raising or start lowering first. At this time, we do not have a tentative date as to when this feature will be implemented.

Similar Threads

  1. LHC+ Level Editing and Cycle Dim
    By Armando B. in forum Design Assistance - HWQS
    Replies: 4
    Last Post: 07-20-2018, 10:14 AM
  2. Cycle Dim and Integration Programming
    By Armando B. in forum Programming - HWQS
    Replies: 2
    Last Post: 12-31-2015, 12:23 AM
  3. IR qs keypads
    By jimathome in forum General Discussion - HWQS
    Replies: 1
    Last Post: 11-04-2014, 01:05 PM
  4. HWQS - just too slow to catch double tap and cycle dim ?
    By JDearden in forum Troubleshooting - HWQS
    Replies: 12
    Last Post: 05-11-2014, 04:29 PM
  5. LED State unknown after initial transfer
    By rdgerken in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 11-19-2013, 08:32 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •