-
Programming time out after 20 minutes
How do i program a HQRD -8ANS to turn on a fan and time off after 20 minutes
-
Program a sequence where step 1 turns the fan on, the stop sequence turns it off. Check "Automatically go to next step after (time)."
Under program-devices, click the "device location" drop down and check "show all dimmers"
You can now assign the sequence to the switch.
When they turn the fan on, it will run for the time you specified in the sequence. If the press the 8ANS before the timeout, it will go to the next (off) step.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
-
Originally Posted by
randyc
Program a sequence where step 1 turns the fan on, the stop sequence turns it off. Check "Automatically go to next step after (time)."
Under program-devices, click the "device location" drop down and check "show all dimmers"
You can now assign the sequence to the switch.
When they turn the fan on, it will run for the time you specified in the sequence. If the press the 8ANS before the timeout, it will go to the next (off) step.
so i set sequence to 20 minutes and auto stop, do i check 1 loop or time. Also noticed the selected 8ANS says setting is Lock?
-
1 loop. Don't use the lock feature. I believe that locks out the 8ans so they can't use it again until it is unlocked.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes