Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Momentary button like Raise & Lower...

  1. #1
    Junior Member
    Join Date
    Oct 2013
    Posts
    29

    Momentary button like Raise & Lower...

    I've got an application where we want to close a switch contact (of an RPM R module) ONLY as long as a given button is held. This is just like the way the raise/lower buttons work with respect to dimming anyway. I was assuming I could use Dual-Action, but something about it (I rarely use dual-action unless for the occasional double-tap) makes me think it won't work. Am I over thinking it? "Press ON" to turn on load, "Release" to turn it off under the Dual-Action settings. Better ideas??

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513
    With a dual action button type, if the press has lights going on, and the release has lights going off, the lights will be on as long as the button is pressed and held, then the lights will turn off when the button is released.

Similar Threads

  1. WCI Raise or Lower Scene with a Hold
    By Armando B. in forum Programming - HWQS
    Replies: 10
    Last Post: 02-10-2022, 04:52 PM
  2. Raise or Lower on Last Button Double-Tapped
    By thomod in forum General Discussion - RA2
    Replies: 2
    Last Post: 09-02-2014, 12:57 PM
  3. Trying to raise and lower fixtures just programmed to that button
    By yaniquevirgo in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 07-31-2014, 02:50 PM
  4. Raise and Lower buttons Affecting Scenes Conditionally
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 05-27-2014, 05:09 PM
  5. Master Raise/Lower Time
    By domino in forum Programming - HWQS
    Replies: 1
    Last Post: 11-18-2013, 08:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •