Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Question on Engraving of Wall Plates in addition to keypad buttons

  1. #1
    Junior Member
    Join Date
    Jun 2018
    Posts
    11

    Question on Engraving of Wall Plates in addition to keypad buttons

    I noticed on the software for ra2, there is an option to have engraving done on Plates also? IS this correct? if so any idea on what Lutron charges to do that?

  2. #2
    Junior Member
    Join Date
    Jun 2018
    Posts
    11
    i found my answer but in case anyone else is wondering Lutron Charges $25 per gang plus plate cost to do additional engraving

Similar Threads

  1. Engraving & Ordering See Touch Face Plates
    By 39CentStamp in forum Design Assistance - HWQS
    Replies: 1
    Last Post: 03-19-2018, 03:03 PM
  2. Keypad buttons
    By Anthony in forum Design Assistance - RA2
    Replies: 3
    Last Post: 05-22-2017, 11:59 AM
  3. Laser engraving Claro wall plates and Ra2 buttons?
    By wkearney99 in forum Design Assistance - RA2
    Replies: 5
    Last Post: 03-24-2017, 10:59 PM
  4. Need Bigger Keypad Buttons
    By schalliol in forum General Discussion - RA2
    Replies: 1
    Last Post: 02-10-2016, 08:03 PM
  5. 7 Buttons on a Hybrid Keypad?
    By michael.eskinazi in forum General Discussion - RA2
    Replies: 3
    Last Post: 07-13-2015, 11:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •