Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: Exhaust Fan on 4U RPM Module

  1. #1
    Junior Member
    Join Date
    Apr 2017
    Posts
    6

    Exhaust Fan on 4U RPM Module

    QS Designer program allows switched fan loads to be assigned to 4U modules. Ideally, they should be on switch modules, but if an exhaust fan is assigned to a forward-phase module, does the module treat that load differently than a light load (other than changing the ramp times to the minimum setting)? Does it have the ability to bypass the dimming engine? And, another question would be: "would the fan be harmed in any way if assigned to a dimmer" (as it is a motor).

    Thanks in advance.

    Regards,
    --David

  2. #2
    Senior Member
    Join Date
    May 2013
    Posts
    420
    Hello Toslink,
    Thank you for your post.
    This appears to be an oversight in the software. The RPM-4U is not rated to control a fan load type. I have let our development team know of the software issue.

  3. #3
    Senior Member
    Join Date
    Sep 2014
    Posts
    269
    Do we have the same issue putting an exhaust fan on a 4A module set to non-dim?

Similar Threads

  1. Twist on programing an exhaust fan!!!
    By vacuatus in forum Programming - HWQS
    Replies: 4
    Last Post: 03-16-2018, 03:42 PM
  2. Exhaust Fan Control
    By phmartin in forum Design Assistance - RA2
    Replies: 1
    Last Post: 04-17-2016, 09:45 PM
  3. Exhaust Fan Timer Programming
    By Matt@ADG in forum Programming - HWQS
    Replies: 2
    Last Post: 06-02-2015, 10:09 AM
  4. Replies: 1
    Last Post: 12-10-2014, 11:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •