Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Control & Signal Cables

  1. #1
    Junior Member
    Join Date
    Jul 2018
    Posts
    1

    Control & Signal Cables

    The manufacturer of my LED driver also makes an interface module that works in conjunction with the Lutron DVTV, 0-10V, low voltage, dimmer switch. They are specifying a "signal wire" to run from the switch to the interface. Hate to be so thick, but can someone name 2 or 3 suppliers of this type of wire, along with the corresponding part numbers? Thanks.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    I'm not aware of a specific part number. You will need a 2-conductor cable from the dimmer to the LED driver(s). You can daisy chain the fixtures. The size of the cable will be determined by total length but will typically be 18-22 gage. Since the cable is going in the box with the line voltage (dimmer) it will need to be rated for 600v.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. NVP - Nominal Velocity of Propagation for Lutron cables
    By ekimla in forum Troubleshooting - Quantum
    Replies: 3
    Last Post: 05-02-2023, 06:56 AM
  2. Replies: 3
    Last Post: 10-02-2017, 10:56 AM
  3. Transfer light control signal over RS-485
    By vidgeek897 in forum 3rd-party Integration - CAS
    Replies: 1
    Last Post: 03-17-2017, 04:36 PM
  4. LED remaining on after pulse signal
    By electricrussell in forum Programming - RA2
    Replies: 3
    Last Post: 06-02-2014, 11:05 AM
  5. RF Signal Strength
    By mcignarella in forum General Discussion - HWQS
    Replies: 2
    Last Post: 10-07-2013, 03:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •