Replace Diva DVELV-303p with Casetta PD-6WCL

[pbrace]

I am trying to replace a Lutron Diva DVELV-303p with a Casetta in Wall dimmer.

I have tied off three wires at one end (per instructions).

At the Diva end I have four wires. They are Wall Black to Diva Yellow, Wall white 1 to Diva Red/white, Wall white 2 to Diva White, and wall red to Diva red.

I cannot figure out how to connect this array of wires to the Casetta dimmer.

I have installed a dozen Casetta dimmers without problems. This one is stumping me. Please help.

Thanks.





Sent from my iPad

[randyc]

http://www.lutron.com/TechnicalDocum...structions.pdf

If you look at page 21 of the advanced instructions (link above), there are 2 options. For both options connect the white to white, ground to ground.

If the Diva was installed correctly you should use the 2nd diagram. Connect the Diva red & red/white (wall white1 & red) to the Caseta black. Connect the Diva yellow (wall black) to the Caseta red.

If you have the other application, use the upper diagram. Connect the Diva red & red/white (wall white1 & red) to the Caseta red. Connect the Diva yellow (wall black) to the Caseta black.

You noted that you have a white wire connected to the red/white on the diva. This is NOT a neutral. Do not connect it to the white wire on the Caseta.

Good luck!