Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Wall plate won't fit Grafik T keypad?

  1. #1
    Junior Member
    Join Date
    Jul 2017

    Wall plate won't fit Grafik T keypad?

    I've got a box with 4 Grafik T dimmers, and the wall plate works great.

    I've got a second box with 1 Grafik T keypad and 1 Grafik T dimmer, and the keypad has a clear piece of plastic sticking out at the bottom to the left of the disconnect tab... and the wall plate doesn't fit over it.

    Am I supposed to remove that tab, or cut away part of the faceplate, or...?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Do not remove it. That is the dynamic backlighting management sensor. There was an earlier thread about this but I don't think it was resolved. You should contact tech support for the solution.
    LED, Incorporated
    Raleigh, NC 27614

Similar Threads

  1. Replies: 8
    Last Post: 06-14-2018, 08:44 PM
  2. HWI European Keypad compatible with Grafik Eye GRX-3000 series?
    By lighthoos in forum General Discussion - Legacy HW
    Replies: 1
    Last Post: 04-13-2017, 04:24 AM
  3. Cost of installing Grafik Eye QS vs dimmers and a keypad
    By ultravelocity in forum Programming - RA2
    Replies: 2
    Last Post: 06-18-2015, 01:17 PM
  4. Grafik Eye Shade keypad for lighting scenes?
    By sblunden in forum Programming - RA2
    Replies: 2
    Last Post: 05-19-2015, 03:52 PM
  5. What is the difference hybrid and wall-mount keypad
    By Anna W. in forum Design Assistance - RA2
    Replies: 8
    Last Post: 04-28-2014, 07:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts