Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: Quantum system trigger by third party via RS232

  1. #1
    Junior Member
    Join Date
    Apr 2014

    Quantum system trigger by third party via RS232

    We have a Quantum project, it have 4 pcs of QSNE-4S10-D, 1pcs of QSNE-4T10-D and 2pcs of QSNE-2DAL-D.
    All the programming is already finished, but the A.V. system send out RS232 to NWK for Raising or Lowering the area light level will have delay, when they release the button, it will send command Stop Raising/Lowering to NWK as same time, but the light fixture still dimming down the level, and it will stop around 2-3 second, is it normal? if not, any setting can improve this delay problem?

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    For the best integration troubleshooting assistance for the commercial Quantum system, please email with the following information:

    - Commands being sent to the NWK from the press and release buttons
    - When do you see the feedback in the NWK that the stop command was sent
    - If you send the commands to the NWK from a telnet session, do you experience the same delay?
    - What else is connected on the network with the AV system and the NWK?

  3. #3
    Junior Member
    Join Date
    Aug 2021
    We have just gotten our installation of the Quantum System and are trying to communicate via Crestron and RS232. How can I test communication to the NWK via RS232? I have tried sending #DEVICE,[\DEVICEID],6,0\r, with [DEVICEID] being one of the wall buttons pads to turn off the lights, and nothing happens. I am able to see in the Crestron processor that the comm device is online, just not sure if it is communicating with the NWK.


Similar Threads

  1. Suggestions on how to integrate a split-system ductless HVAC system with RadioRA2
    By RA2-Designer-Gal in forum Design Assistance - RA2
    Replies: 4
    Last Post: 05-10-2017, 11:43 AM
  2. Extron via RS232 or ethernet to change HomeWorks QS scene setting
    By hkfiresoul in forum 3rd-party Integration - HWQS
    Replies: 10
    Last Post: 02-11-2015, 09:43 AM
  3. Setting HVAC Setpoint from a Third Party System
    By Armando B. in forum 3rd-party Integration - HWQS
    Replies: 0
    Last Post: 04-21-2014, 01:00 PM
  4. 3rd-party integration (RS232)
    By Ty W. in forum Design Assistance - HWQS
    Replies: 1
    Last Post: 06-20-2013, 05:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts