Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: GRX-IRPS-WH Partition Sensors

  1. #1

    GRX-IRPS-WH Partition Sensors

    Some partition wall installed on a project does not have dry contacts to signal the door being open or closed. Can these be used on a HWQS system. If so, how are they implemented in the programming. I have 3 partitions. Thanks in advance!

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513
    The partition wall does not need to have dry contacts. The GRX-IRPS-WH sensors would need to be placed on opposite sides on the wall and they will keep an infra red beam of communication between them. This sensor will connect to the QSE-IO input and common. When the sensor IR signal is communicating (the wall is open), the IRPS will maintain an active high signal of 24V to the QSE-IO. When the sensor is not communicating, the signal will be at 0V. All three sensors can be connected to a separate input of the QSE-IO. It is not a dry contact connection.

    See the wiring diagram with the IO in the link below

    http://www.lutron.com/TechnicalDocumentLibrary/irps.pdf

Similar Threads

  1. Occupancy/vacancy sensors
    By Ekkoville in forum General Discussion - CAS
    Replies: 5
    Last Post: 04-14-2016, 01:46 PM
  2. Sensors To Turn On Exterior Lights?
    By geofry in forum Design Assistance - RA2
    Replies: 2
    Last Post: 06-24-2014, 02:40 AM
  3. Homeworks QS Partition walls
    By jwbcinergy in forum Design Assistance - HWQS
    Replies: 1
    Last Post: 05-23-2014, 11:53 AM
  4. Pico and Occ Sensors out of programming
    By mandbelectric in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 12-31-2013, 03:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •