Results 1 to 4 of 4

Thread: Controlling dimmer's dimmed position manually

  1. #1
    Junior Member
    Join Date
    Aug 2014
    Posts
    25

    Controlling dimmer's dimmed position manually

    Hi guys,

    This probably has been discussed before. If this is in the FAQ please let me know.

    When a dimmer is just installed and not part of the radioRA2 programming we can set the dimmed position manually at any time and that setting would be retained until we change it again.
    Once it is programmed then I noticed that we can't set the dimmed position manually anymore, it is always back to the "specific dimmed position" that I am not sure from where.

    So then the questions I have:
    1. Is there a way to be able to control the dimmed position manually once it is part of the programming?
    2. Where do you set that dimmed position for a dimmer once it is part of the programming? If it is based on the last scene then it is kind of bad because that would change all the times depending on the last scene used.

    Thanks all.

  2. #2
    Junior Member
    Join Date
    Aug 2014
    Posts
    25
    I found the answer to question #2. It is set in the Advanced settings window (Design tab, right-click on dimmer). Will try this soon.

  3. #3
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    407
    If the "On Level" is set to a level then there is not away to locally change this level. If the "On Level" is set to be the last level then the light will turn on the last level the dimmer was set to locally.

  4. #4
    Junior Member
    Join Date
    Aug 2014
    Posts
    25
    Ok. Thanks Craig.

Similar Threads

  1. Controlling LED's DMX 512 Decoder??
    By ChrisK in forum General Discussion - RA2
    Replies: 11
    Last Post: 04-17-2015, 10:24 PM
  2. Gate Position Monitoring using Keypad LED
    By electricrussell in forum 3rd-party Integration - RA2
    Replies: 1
    Last Post: 07-17-2014, 07:48 AM
  3. RPM-4U Dimmed Load below 100% Will Switch Off
    By Armando B. in forum Troubleshooting - HWQS
    Replies: 0
    Last Post: 07-11-2014, 03:52 PM
  4. Controlling lie voltage shades?
    By thefish in forum Design Assistance - RA2
    Replies: 3
    Last Post: 05-15-2014, 02:35 AM
  5. How does a CL dimmer differ from a Standard Dimmer?
    By BrianWren in forum General Discussion - LED
    Replies: 4
    Last Post: 04-30-2014, 04:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •