Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: issue with CFL lights and rrd-8ans

  1. #1

    issue with CFL lights and rrd-8ans

    In my dining room I have 5 identical CFL's controlled by an 8ans switch (and rd-rs). 1 of the 5 CFL's glows slightly when the switch is off. Any ideas?

    Thanks,
    Eric

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    409
    Eric,

    Do you know if the first light connected to the dimmer is the one experiencing this issue?
    If you swap two bulbs around does the issue remain with the location?
    Also can you please provide us the make and model of the bulbs being used?

  3. #3
    Craig, there are 5 CFL's in a chandelier and I'm assuming they are wired in parallel to each other. The bulbs are all the same and were installed by the builder 3 years ago. This is the only fixture on this circuit, controlled by RRD-8ANS and a RD-RD in a 3-way configuration. TP120-13MSL (GU24) 13W 2700K.

    Eric

  4. #4
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    409
    If you remove this bulb from the chandelier does another bulb then experience this issue?

Similar Threads

  1. Replies: 3
    Last Post: 06-12-2017, 10:43 AM
  2. Raise Lower DMX RGB Lights and Incandescent Lights
    By Armando B. in forum Programming - HWQS
    Replies: 3
    Last Post: 11-12-2014, 12:43 AM
  3. 8ANS to Outdoor GFCI?
    By schalliol in forum Design Assistance - RA2
    Replies: 3
    Last Post: 05-27-2014, 01:36 PM
  4. 8ANS for low voltage fireplace control?
    By dw886 in forum Design Assistance - RA2
    Replies: 4
    Last Post: 04-20-2014, 04:52 PM
  5. 8ANS without a neutral
    By Craig W. in forum General Discussion - HWQS
    Replies: 0
    Last Post: 01-20-2014, 07:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •