-
0-10V wiring with an RPM
I am working on a project and we do not have space in our PNL-8 for a TVM Kit so we were thinking of going with the LMJ-5T-DV-B. I just want to make sure I get this right for wiring. Would I come out of my RPM-4A to the line side of the RF dimming module then from load side I go to fixture and also bring the 0-10V wire to fixture?
Thanks for any help
-
Authorized Lutron Contributor
cabethesda, the LMJ-5T-DV-B would not get wired to the output of a RPM. The unit would get a constant hot to the black wire, switched hot to the red wire and a neutral to the white. The low voltage 0-10v wires would then get plugged into the front of the LMJ-5T-DV-B and run to the ballast or driver of hte fixture.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes