Button Functions (QS Wired Panel ONLY)

The Five buttons in the Power Panel, starting at the top:

  1. Scene 1 on
  2. Scene Off
  3. All Shades on link Open
  4. All Shades on link Closed
  5. Resets blinking Power LEDs (LED will blink if there was a short or miswire on the output until button is pressed or power is cycled)


Diagnostics (QS Wired Panel ONLY)

You can make all shades on link wiggle by the following presses on button 3 (Shades Open):

  1. tap button
  2. hold button until bottom LED flashes (5 seconds)
  3. tap button
  4. hold button until bottom LED flashes (5 seconds)

All shades in the system should now be wiggling.
To exit wiggle mode hold button 3 until the bottom LED stops blinking (5 seconds)