Is there an app note on how to set up the software and program the LQSE-2DAL-D in a Homeworks QS system? I see I need to set up Loops, Zones, Loads, etc.
Thanks: 0
Likes: 0
Dislikes: 0
Is there an app note on how to set up the software and program the LQSE-2DAL-D in a Homeworks QS system? I see I need to set up Loops, Zones, Loads, etc.
OK, to clarify, I will be using the LQSE-2ECO-D. I think I have figured out how to configure it in QS, but how do you activate the LED Drivers/Ballasts? Do you need to push something on the driver itself? Or is there a serial number to enter? I would imagine the drivers get installed with the light fixture, but then are not accessible afterwards? Are they addressed like a shade by flashing the load and then identifying it?
Attached is our application note on using the Eco system ballasts with the LQSE-2ECO-D module (as well as the ECO Grafik Eye QS) in the HomeWorks QS system. Please ensure, after activating the LQSE-2ECO-D, please perform a transfer to the system before activating the ballasts. Details on this procedure are highlighted in the document.
Posting Permissions
Reply With Quote