Thanks Thanks:  1
Likes Likes:  1
Results 1 to 2 of 2

Thread: Engraving Wallplates Above/Below Controls?

  1. #1
    Senior Member
    Join Date
    Sep 2013
    Posts
    450

    Engraving Wallplates Above/Below Controls?

    I have an install about to begin that has a number of basement controls. Yes, I know RR2 isn't designed for ganging a bunch of controls in an equipment room, but that's what we're doing for the outside fixtures (i.e. Pergola Light, Pergola Fan, Sconces, String Lights, Step Lights, Switched Outdoor Outlets, Floods, etc.....). A keypad by the door out to the patio is all we need for everyday use, but since you can't immediately see the feedback of what the control did, labeling them makes sense.

    Is anyone aware of a way to nicely engrave above or below each opening on a Claro wall plate? As far as I know, Lutron only offers labeling on the sides. It won't be seen often, so we could just go with a label maker, but that's not very nice.

    Thanks!

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    403
    Please contact our customer service department at 1-800-523-9466 as they will be able to assist you on placing an engraving order to have the faceplate engraved either above or below the opening for the control.
    Last edited by Brian S.; 07-28-2014 at 11:46 AM.

  3. Thanks schalliol thanked for this post
    Likes schalliol liked this post

Similar Threads

  1. Outdoor Controls
    By schalliol in forum General Discussion - RA2
    Replies: 19
    Last Post: 08-29-2020, 10:41 AM
  2. Engraving Ordering
    By Armando B. in forum General Discussion - RA2
    Replies: 4
    Last Post: 06-08-2015, 06:22 AM
  3. RA 2 Icon Engraving
    By tedrosenberger in forum General Discussion - RA2
    Replies: 1
    Last Post: 02-27-2014, 07:31 AM
  4. Dual (stacked) controls with LEDs
    By Brian W. in forum Design Assistance - Controls
    Replies: 0
    Last Post: 02-06-2014, 09:46 AM
  5. v1.64 Engraving Report - Keypads not displaying correctly
    By Helluvaname in forum General Discussion - Legacy HW
    Replies: 3
    Last Post: 10-18-2013, 06:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •