Thanks Thanks:  0
Likes Likes:  0
Results 1 to 5 of 5

Thread: 6NA PANEL blinking from center outwards

  1. #1
    Junior Member
    Join Date
    Jul 2014
    Posts
    1

    6NA PANEL blinking from center outwards

    One of the 6na dmmers is not cojnecting to the system. turns on and off perfectly if manually set but it is unresponsive to wireless commands. tried deactivating and activating again with no luck (unable to activate) tried resetting the dimmer still notihing. whe trying to activte dimmer after a couple of seconds the leds in the panel light from the center to the top and button. please help

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    403
    Unfortunately this sounds like a dimmer that needs to be replaced.

  3. #3
    Set it back to default, than upload again and see if it becomes alive.
    I am not as dumb as you look..

  4. #4
    Junior Member
    Join Date
    Jun 2014
    Posts
    12
    I'm having a similar issue, even the factory reset seems to not behave as expected. Did this ever get resolved?

  5. #5
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    28
    Unfortunately this sounds like a dimmer that needs to be replaced.

Similar Threads

  1. HWQS Feed Thru Panel
    By Fitz1 in forum General Discussion - HWQS
    Replies: 1
    Last Post: 06-18-2014, 12:32 PM
  2. Programming of CCP Panel
    By hkfiresoul in forum Programming - HWQS
    Replies: 4
    Last Post: 04-15-2014, 02:01 PM
  3. Can I Mount the H48 Board on a Third Party Panel?
    By Armando B. in forum Design Assistance - HWQS
    Replies: 0
    Last Post: 03-03-2014, 03:44 PM
  4. Only the "P" LED is blinking on the processor
    By Craig W. in forum Troubleshooting - Legacy HW
    Replies: 0
    Last Post: 01-20-2014, 06:50 PM
  5. 600w dimmers LEDs blinking - not responding
    By jelston in forum Troubleshooting - RA2
    Replies: 6
    Last Post: 12-20-2013, 01:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •