Thanks Thanks:  1
Likes Likes:  1
Results 1 to 2 of 2

Thread: Gate Position Monitoring using Keypad LED

  1. #1

    Gate Position Monitoring using Keypad LED

    I have a gate that I am controlling with 2 CCOs from a VCRX. The gate operates on a pulsed signal and I am trying to maintain LED status (Keypad LED stays on while gate is open or closed, respectively.) I realize I need a third party system to monitor the gate position because the keypad button LED will only light for the pulse and then go off. Has anyone run into this issue and had any luck integrating to achieve this?

  2. #2
    Senior Member
    Join Date
    May 2014
    You could put an alarm system door contact on the gate and connect it to a CCI on the VCRX. Then use the CCI to set the LED state.
    Danbury, CT

  3. Thanks electricrussell thanked for this post
    Likes electricrussell liked this post

Similar Threads

  1. Monitoring the status of a garage door
    By Craig W. in forum Programming - HWQS
    Replies: 10
    Last Post: 05-27-2014, 01:11 PM
  2. Monitoring if a Timeclock is Enabled or Disabled
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 03-20-2014, 12:43 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts