Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: HWQS Feed Thru Panel

  1. #1
    Junior Member
    Join Date
    Sep 2013
    Posts
    5

    HWQS Feed Thru Panel

    How are you guys determining the feeder size from the main panels for these panels. We have the HWAP--8D-20-120L3.... Everyone I ask I get a different answer from. I see nothing on Lutrons site dictating the size of the feeder. And then we also have the PNL 5 version too.....

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513
    Please reference page 2 of the install sheet attached. The Main Lug will accept wire up to 2/Ø. Tighten Lug to 50 in-lbs. (5.6 Nm) for #14 to 8 AWG and 120 in-lbs. (13.5 Nm) for #6 to 2/Ø. The HWBP8D-20-120L3 and HWBP-8D-15-120L3 should be fed with an 80A single-phase feed. The HWBP-8D-20120L4 and HWBP-8D-15-120L4 should be fed with a 60A three-phase feed. All module and control feed wiring is pre-wired.
    Attached Files Attached Files

Similar Threads

  1. MI Panel Troubleshooting - List of good steps to take
    By Armando B. in forum Troubleshooting - HWQS
    Replies: 0
    Last Post: 06-13-2014, 04:35 PM
  2. Programming of CCP Panel
    By hkfiresoul in forum Programming - HWQS
    Replies: 4
    Last Post: 04-15-2014, 02:01 PM
  3. Can I Mount the H48 Board on a Third Party Panel?
    By Armando B. in forum Design Assistance - HWQS
    Replies: 0
    Last Post: 03-03-2014, 03:44 PM
  4. Convert Sivoia QS Wireless from Battery to CSPS-P1-10-6 Power Panel
    By jfbordenjr in forum General Discussion - Shades
    Replies: 4
    Last Post: 11-07-2013, 05:36 PM
  5. QSPS-P1-10-60 (Power Panel) Button Functions and Diagnostics
    By Blair S. in forum Troubleshooting - Shades
    Replies: 0
    Last Post: 07-29-2013, 01:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •