Hi
Ive got a strange issue going on with my system. HW illumination Version 1.65
I have 8 loads 2 different modules that are having 3-5 sec delay coming on but they also will not come on if not set to 100% if set any lower they don’t come on
Trouble shooting I tried
·Changed out keypad to new keypad
·Changed out 4u module with new
·Changed out M.I with new
·Changed out wiring harness from M.I to modules
·Checked programming (everything looks ok to me )
Loads with issues are the following
Quad C Basement\Mechinical Room B13\LCP1
Module:4 Outputs 1-4
Module:7 Outputs 1-4
3-5 sec delay turning on
If dimming lvl lower than 100% lights don’t turn on
I have 15 other LCP panels none of them are having this issue just this on panel.