If I open a client to gateway VPN and then initiate a transfer the transfer screen will pop up the find Main Rep screen.
Code:
7:43:14 PM: Please select the serial number of the repeater in the corresponding room.
7:43:20 PM: No main repeaters were found on the network. Please check if the main repeater is properly connected to the network and click Refresh.
7:45:32 PM: Communication to the repeater with serial number 0085981E failed. Please check if the main repeater is properly connected to the network and click "Refresh."
If I go from design>main rep location>find main I get Status Online
Code:
7:50:33 PM: Please select the serial number of the repeater in the corresponding room.
7:50:43 PM: Found 1 main repeater on the network.
If I go to a browser and type the IP of the Main Rep I get the log in screen.
I'm now trying with 7.5 and still no joy. I did recently change my office network by adding a new router and a layer 3 switch and now my PC sits behind a cheap L2 switch > Cisco 2960 L2 switch > Cisco SG500-28 L3 switch > Router. I have no ACLs denying protocols or ports and I have no problems remotely connecting to other systems (AMX, HomeWorks, HAI, Cisco, etc) but no luck with RA2 since something changed. Since everything else I remote into still works I'd say it's a RA2 issue.