Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Dual 0-10V inputs on a fixture

  1. #1
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    Posts
    403

    Dual 0-10V inputs on a fixture

    We had a customer who had a fixture that had one 0-10V input to control the intensity of the fixture and other 0-10V input used to control the color of the fixture. For this application you would need to define 2 different 0-10V loads in the project file, one for the intensity and one for the color. These loads would then be assigned to the corresponding outputs on the RPM. You would then either need to use 2 separate outputs on the TVM2 modules or use a GRX-TVI interface on each of these outputs to get the 0-10V control.

  2. #2
    Junior Member
    Join Date
    Apr 2015
    Posts
    2

    0-10 volt control

    Quote Originally Posted by Craig W. View Post
    We had a customer who had a fixture that had one 0-10V input to control the intensity of the fixture and other 0-10V input used to control the color of the fixture. For this application you would need to define 2 different 0-10V loads in the project file, one for the intensity and one for the color. These loads would then be assigned to the corresponding outputs on the RPM. You would then either need to use 2 separate outputs on the TVM2 modules or use a GRX-TVI interface on each of these outputs to get the 0-10V control.
    Yes have install and tested all loads. I need to control these fixtures with one button. Home has all recess fixtures this type. 2 Buttons for each room to control 0-10 dim and 0-10 color corrective dimming most rooms have more than one load. 2 buttons to control one load bit much. Has anyone not done this.

Similar Threads

  1. Assign Inputs/Outputs Pop-up Missing or Disappeared
    By Ty W. in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 05-11-2017, 01:50 PM
  2. Replies: 0
    Last Post: 03-20-2014, 12:36 PM
  3. Dual (stacked) controls with LEDs
    By Brian W. in forum Design Assistance - Controls
    Replies: 0
    Last Post: 02-06-2014, 09:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •