Thanks Thanks:  1
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: HWQS WPM Zone Labels

  1. #1

    HWQS WPM Zone Labels


    With the HWQS WPMs operating the 7-32 firmware, is it ok to use the GrafikEye QS Single Unit Programmer 7.031 (Build 004) to only update the zone names of the WPM? It's tedious to do it manually on the WPMs, so just looking for a faster method. I just tried doing it and all seems fine "so far"...

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    We have not tested the Grafik Eye QS single programmer functionality with the WPM devices. If it is working with your application, we do not see any issues that should arise with using the programmer with the WPMs. However, we cannot guarantee that changes made with the programmer will remain if the HomeWorks QS system does another transfer to the WPM.

  3. Thanks ekimla thanked for this post

Similar Threads

  1. mixed loads in a zone- will QS adaptive dimmer work
    By digit1 in forum General Discussion - LED
    Replies: 1
    Last Post: 11-26-2013, 09:37 AM
  2. Obtaining a true switched output from a WPM zone
    By Helluvaname in forum General Discussion - LED
    Replies: 9
    Last Post: 10-17-2013, 07:15 PM
  3. Multi-Zone Temperature Control
    By schalliol in forum Design Assistance - RA2
    Replies: 1
    Last Post: 10-02-2013, 10:59 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts