Thanks Thanks:  1
Likes Likes:  2
Results 1 to 2 of 2

Thread: Addressing Shades that were Previously in Another System

  1. #1
    Authorized Lutron Contributor
    Join Date
    May 2013

    Addressing Shades that were Previously in Another System

    We had a dealer that was having difficulties addressing a Honeycomb shade that was in a previous system to his current RadioRa2 system. We thought this information would be useful to shade:

    When in activation, the shade would blink once a second because it was activated to a system; unfortunately, not the system at hand thus it would not communicate, re-activate, or transfer.

    It is necessary to out-of box the shade first to remove the association with the other system in order to be able to communicate to the current RadioRa2 system. After it was out-of-boxed, it activated and transferred normally.

  2. Thanks Eric H. thanked for this post
    Likes Eric H. liked this post
  3. #2
    Authorized Lutron Contributor
    Join Date
    Aug 2013
    For instructions on how to restore factory default settings (out-of-box) for Honeycomb shades, click on the link below:

  4. Likes Armando B. liked this post

Similar Threads

  1. Suggestions on how to integrate a split-system ductless HVAC system with RadioRA2
    By RA2-Designer-Gal in forum Design Assistance - RA2
    Replies: 4
    Last Post: 05-10-2017, 12:43 PM
  2. TVM2 addressing
    By totesthouse in forum Design Assistance - HWQS
    Replies: 3
    Last Post: 01-15-2014, 09:49 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts