Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Adding Triathlon shades to Ra2

  1. #1
    Junior Member
    Join Date
    Feb 2014

    Adding Triathlon shades to Ra2


    I have a jobsite where the shading company installed triathlon shades - I have a Ra2 system in place and would like to add these shades to the system. They are currently programmed to a Pico remote. I can't seem to discover the shades during programming. Any tips?


  2. #2
    Authorized Lutron Contributor
    Join Date
    Aug 2013
    Since Pico controls were previously assigned to the shades, you may need to factory reset the shade drives in order to activate them into the RadioRA 2 system. To factory reset the shades, follow the instructions in the "Restoring Factory Default Settings" sections of the install guides posted below. One of the install guides below is for the Triathlon Insulating Honeycomb shades and the other is for the Triathlon Roller shades. Click on the link that applies to the type of shades you are trying to activate. (Insulating Honeycomb shades) (Roller shades)

Similar Threads

  1. Triathlon Roller Submittal?
    By digit1 in forum Design Assistance - Shades
    Replies: 1
    Last Post: 02-07-2014, 11:23 AM
  2. Aurora - Adding a replacement dimmer/switch
    By Blair S. in forum Programming - Controls
    Replies: 0
    Last Post: 07-29-2013, 07:38 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts