Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: poll all LED's

  1. #1

    poll all LED's

    Is there a command that will poll for all device's LED and dimmer levels at once? Based off the protocol doc there is only the ability to request LED status on a button by button basis which can get cumbersome.

    I would have expected setting LED monitoring to ON would report all devices current states when sent but that does not seem to happen either. Thanks.

  2. #2
    Authorized Lutron Contributor
    Join Date
    Apr 2013
    There is not a command that will poll the system and command would need to be sent for each integration ID. With monitoring enabled when and device or status LED change states you would be provided the feedback to indicate the change that occurred.

Similar Threads

  1. Firmware Update or Transfer Stuck
    By Armando B. in forum Best Practices - RA2
    Replies: 0
    Last Post: 02-10-2014, 05:22 PM
  2. Update Processor Firmware, Necessary or Not ?
    By stevi in forum General Discussion - HWQS
    Replies: 1
    Last Post: 11-12-2013, 04:08 PM
  3. Dynamic Keypad Firmware Update
    By ekimla in forum Troubleshooting - HWQS
    Replies: 5
    Last Post: 11-11-2013, 09:53 PM
  4. Firmware Update
    By suprun in forum Programming - RA2
    Replies: 1
    Last Post: 11-11-2013, 09:58 AM
  5. Software request-Update Touchpros
    By thefish in forum General Discussion - HWQS
    Replies: 1
    Last Post: 10-24-2013, 09:32 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts