Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Simple Occupancy Fan System Setup

  1. #1
    Junior Member
    Join Date
    Apr 2018
    Posts
    2

    Simple Occupancy Fan System Setup

    Hello this is my first time posting in this forum,

    I am interested in setting up a fan occupancy system and i was looking at the following parts.

    LRF-2-O-W-LB-P-WH Lutron IR wall sensor, battery operated
    RMJ-H20R-DV-B Lutron Powpak 20A relay module rated for 1.0 HP (120v)
    MA-FQ4FM-WH Lutron 7 speed fan controller

    The fan that is being power is the following:
    https://www.homedepot.com/p/Hampton-Bay-Industrial-60-in-Indoor-White-Ceiling-Fan-with-Wall-Control-52860/204507386

    Would these parts be compatible with each other? Let me know if i can provide additional details or information. Thank you.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    The fan you listed has its own wall-mount control. The documentation is not clear if the fan has its own canopy module (receiver) or it is built into the electronics of the fan. The MA-FQ4 requires a Lutron CM-FQ1 (included in package) canopy module. Even if you could replace the Hampton module with the Lutron module there is always the possibility that the speed of the motor may change or get reversed.

    Depending on your layout, you could use a MS-OPS5 in-wall sensor to control power to the Hampton wall control.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Apr 2018
    Posts
    2
    Hey thanks for the response. So i actually already have the ir sensor setup previously for the lighting, but i would like to reuse this same sensor and get it to work the fan also. Would you recommend if i should still use the ir sensor and relay module and used the included wall-mount control for the fan?

Similar Threads

  1. Changing the Occupancy settings on a Lutron EnergiSavr system
    By Joe M. in forum Programming - General Commercial
    Replies: 0
    Last Post: 09-02-2016, 04:39 PM
  2. simple Title 24 compliance?
    By tom31415926 in forum General Discussion - Controls
    Replies: 0
    Last Post: 07-31-2016, 07:56 PM
  3. Simple On/Off Switch with Caseta? Anything likely to happen
    By adams in forum General Discussion - CAS
    Replies: 7
    Last Post: 11-20-2015, 06:25 PM
  4. Simple bathroom remodel
    By alsanmateo in forum Design Assistance - CAS
    Replies: 1
    Last Post: 07-04-2015, 12:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •