Thanks Thanks:  1
Likes Likes:  2
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Switching on 4A or 4U

  1. #1

    Switching on 4A or 4U

    Using Homeworks QS v6.1.0.

    I know that I can put a inc/hal switched circuit on a 4A or 4U but why when I put a switched fluorescent it says that I need to add a PHPM-SW-DV-WH? Its just a switched circuit non dim!

  2. #2
    All four outputs on a 4A or 4U need to be at zero for the internal relay to click off. So if any of the four outputs are "on" you will get a (shockable) amount of current flow on the other outputs when they are set to "off". Normally this is not a problem but when you connect a non-dimming ballast to a 4A or 4U, and any of the other outputs are "on", this current leakage can sometimes cause the fluorescent fixture, while "off", to flicker.

  3. Thanks Armando B. thanked for this post
    Likes Armando B., LightBrigade liked this post

Similar Threads

  1. Switching DMX loads in HWQS with a Separate Control Device
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 02-10-2014, 05:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •