Thanks Thanks:  1
Likes Likes:  2
Results 1 to 7 of 7

Thread: Reverse Waterfall

  1. #1

    Reverse Waterfall

    Hello , i have new QS system with about 40 keypads , few dimmers and few shades. It worked perfectly for about 2 monts. The project is still under construction , mostly painting and plastering. I have all the keypads blue taped. I noticed that noting is working last night. I have the reverse waterfall on all the keypads and red error blinc code on the processor. I am on my way to troubleshoot it right now and wanted to get some ideas or tips before i take all the keypads off. It has to be something with the wiring.

  2. #2

    Fixed!

    So I unplugged all the keypads from the landing board and plugged only one directly into the processor. Than I started plug in al the areas one by one until i located the bad one. It was one of the jumpers. I am glad that we wired it with two home runs to each loop.

  3. Thanks Blair S. thanked for this post
    Likes randyc liked this post
  4. #3
    Now the question is “What changed?” If the system has been working for 2 months, something had to have changed.
    Audio, Video, Networking, & Automation Designed Around You

  5. #4
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,835
    He said there was ongoing construction. I got the impression a wire was damaged/cut/nailed/stapled/etc.
    LED, Incorporated
    Raleigh, NC 27614

  6. Likes Blair S. liked this post
  7. #5
    Junior Member
    Join Date
    Jun 2020
    Posts
    2
    I have also the same issue .

  8. #6
    Authorized Lutron Contributor
    Join Date
    Sep 2018
    Posts
    155
    Thank you for your post perkeini.

    This blink code is a point to an issue with communication. We would break down the link to as simple as possible and then build it out. With this process you will be able to determine if the issue is the wiring or device.

  9. #7
    Junior Member
    Join Date
    Aug 2020
    Posts
    1
    Than I started plug in al the areas one by one until i located the bad one. It was one of the jumpers. I am glad that we wired it with two home runs to each loop.

Similar Threads

  1. Keypads waterfall effect
    By Paul O in forum Troubleshooting - Legacy HW
    Replies: 7
    Last Post: 11-19-2018, 10:19 AM
  2. Keypads Waterfall Effect
    By Saturnus in forum Troubleshooting - Legacy HW
    Replies: 1
    Last Post: 03-20-2017, 09:02 AM
  3. Reverse shades - bottom to top
    By Veiss in forum General Discussion - Shades
    Replies: 1
    Last Post: 08-16-2016, 05:23 PM
  4. Reverse Phase Ceseta?
    By Scott29 in forum General Discussion - CAS
    Replies: 3
    Last Post: 05-01-2015, 02:35 PM
  5. Advanced phase= reverse, forward
    By Scottydont in forum Troubleshooting - RA2
    Replies: 5
    Last Post: 06-10-2014, 03:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •