Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Micro-PIR Sensors at Bed Ends

  1. #1
    Junior Member
    Join Date
    Mar 2018
    Posts
    2

    Micro-PIR Sensors at Bed Ends

    Hi
    I have some 12VDC Micro-PIR sensors going into the baseboards at bedsides in 3 bedrooms. These will be programmed for night scenes when the client gets up at night. Thet are tiny and will activate when someone gets out of bed and puts their feet on the floor.
    I was planning on integrating these into a QSE-IO Module. Each bedroom will be will be one zone (2 X sensors).

    My question relates to wiring and powering of these.

    Can I just run cables to the panel area and use a 12V power supply for the live and the common on the sensors then connect to the IO CC Inputs and Common similar to the diagrams on the QSE-IO Spec sheet? I

    Any advice would be great as I've never used third party gear with HWQS and these clients are insistent on nighttime sensor control. Thanks! Steve

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    I'm not familiar with your device but yes. If the QSE-IO sees a closure between CCI1 and Com, HQS will do what ever you have programmed. The QSE-IO gets power from the HQS bus and DOES NOT provide output power for any other device. It looks like it will accept 12v on the CCI so even if your sensor passes the full voltage through, it should be ok.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. Wireless Occupancy sensors
    By inkontrol in forum Programming - HWQS
    Replies: 6
    Last Post: 04-04-2018, 07:07 PM
  2. Daylight Sensors
    By ibernstein in forum Design Assistance - HWQS
    Replies: 3
    Last Post: 02-20-2018, 03:27 PM
  3. Rollback and occupancy sensors?
    By wkearney99 in forum Best Practices - RA2
    Replies: 5
    Last Post: 06-21-2017, 04:25 PM
  4. Leak Sensors
    By BigDaddyJG in forum General Discussion - CAS
    Replies: 1
    Last Post: 08-04-2016, 09:45 AM
  5. 3rd party occupancy sensors
    By mehuneau in forum Programming - HWQS
    Replies: 3
    Last Post: 07-20-2015, 11:20 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •