Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Integrating a LOS-CDT-200-WH

  1. #1
    Junior Member
    Join Date
    Mar 2018
    Posts
    4

    Integrating a LOS-CDT-200-WH

    Here's my setup:

    One GRX-3504, A1
    Two wallstations, addresses 1 and 2
    One GRX-AV
    One LOS-CDT-200-WH connected to this GRX-AV, with the intent of serving as an occupancy sensor.

    I have put the OS in 8-second test mode and connected it to Common-1 on the inputs of the GRX-AV. I have also gotten the GRX-3504 to "listen" to the GRX-AV on input 1 only (the only input I'm using). I have set the DIP switches to OS1 mode.

    If I stay put for 8 seconds, the lights stay on. If I pull the "1" input wire, the lights still stay on. Am I missing something?

    Thanks!

  2. #2
    Junior Member
    Join Date
    Mar 2018
    Posts
    4
    Update: the original installer wired it incorrectly.

Similar Threads

  1. Integrating with Wink Hub
    By randyc in forum 3rd-party Integration - CAS
    Replies: 1
    Last Post: 10-15-2017, 11:09 AM
  2. Integrating with RF
    By spherex in forum 3rd-party Integration - RA2
    Replies: 6
    Last Post: 03-22-2017, 10:55 PM
  3. Integrating With URC MX880i
    By Debbie in forum 3rd-party Integration - HWQS
    Replies: 1
    Last Post: 06-15-2015, 04:37 PM
  4. Integrating Radio Powr Savr sensors into RadioRA 2
    By Corey in forum General Discussion - RA2
    Replies: 3
    Last Post: 04-08-2015, 05:21 PM
  5. Integrating Sivoia QS wired/wireless shades with HW Illumination
    By Blair S. in forum 3rd-party Integration - Legacy HW
    Replies: 0
    Last Post: 07-29-2013, 08:28 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •