Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5

Thread: Pre wire for shades

  1. #1
    Junior Member
    Join Date
    Oct 2013
    Posts
    14

    Pre wire for shades

    Looking for dimensions or distances to rough in required 4 wire to shade locations, inside mount. Looking for proper placement to drill holes, how far from window? or how far from trim towards the window? How far from frame? Top mount or side mount. potential shades involved are rollers and Venetians. Looking to pre wire in a safe place that doesn't get in the way of brackets and can stay hidden with in the shade with out affecting its location in the window or performance.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    433
    This document page 5 will help with qs roller shade

    http://www.lutron.com/TechnicalDocum...ry/045133a.pdf

  3. #3
    Junior Member
    Join Date
    Oct 2013
    Posts
    14
    Okay! good start. My question now is, can the pocket be related to inside window mount applications that don't have a pocket? If we want those blinds flush with the trim work, where should those wires be installed so we aren't too close to the window and don't screw up the positioning of the brackets?

  4. #4
    Senior Member
    Join Date
    May 2013
    Posts
    420
    In our Sivoia QED TRG we have a section that specifies where to run the wiring based on application.
    This can be applied to Sivoia QS as well. ( I believe with little to no exceptions) Here is a link. http://www.lutron.com/TechnicalDocum...QED_wiring.pdf

  5. #5
    Junior Member
    Join Date
    Oct 2013
    Posts
    14
    Right on Blair, thats looking better! Much appreciated!

Similar Threads

  1. Hardware Request: 3-wire RPM & WMPM
    By mjs@ehi in forum General Discussion - HWQS
    Replies: 1
    Last Post: 10-24-2013, 09:52 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •