-
PJ-3BRL wall switch blinking, won't respond to remote
We had 2 sets of recessed LED lights installed a few years ago.
One set is still working fine, the other set started acting up yesterday.
The little green lights on the wall switch are blinking rapidly - either the top light or the bottom light blinks, depending on what the last setting of the dimmer was.
It will no longer respond to the remote at all. I tried re-programming the remote but the wall switch won't exit setup mode on its own, making me think it isn't listening to the remote at all.
I can turn the lights on and off using the switch, but when they don't brighten and dim smoothly - the light increases or decreases in jerky stages.
The other set of lights powers on and off smoothly and the remote works fine with that set. (we have both remotes programmed to work with both sets of lights)
Ideas?
-
Make sure you have the minimum load: 25 watts of incandescent or 1 compatible LED.
Try pulling the gap switch on the dimmer. It is a small pull out tab below the off button. Give it 10 seconds or so and push it back in.
If that doesn't work. You may need to reset back to factory defaults. This will unpair the device and reset trim levels.
Triple tap (very fast) and hold the on button until the lights flash.
Release and triple tap again within 1/2 second.
-
Randyc, pulling out the gap switch for 10 seconds fixed the problem. Thank you!
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes