Thanks Thanks:  0
Likes Likes:  1
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: PJ-3BRL wall switch blinking, won't respond to remote

  1. #1
    Junior Member
    Join Date
    Feb 2018
    Posts
    2

    PJ-3BRL wall switch blinking, won't respond to remote

    We had 2 sets of recessed LED lights installed a few years ago.

    One set is still working fine, the other set started acting up yesterday.

    The little green lights on the wall switch are blinking rapidly - either the top light or the bottom light blinks, depending on what the last setting of the dimmer was.

    It will no longer respond to the remote at all. I tried re-programming the remote but the wall switch won't exit setup mode on its own, making me think it isn't listening to the remote at all.

    I can turn the lights on and off using the switch, but when they don't brighten and dim smoothly - the light increases or decreases in jerky stages.

    The other set of lights powers on and off smoothly and the remote works fine with that set. (we have both remotes programmed to work with both sets of lights)

    Ideas?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,148
    Make sure you have the minimum load: 25 watts of incandescent or 1 compatible LED.

    Try pulling the gap switch on the dimmer. It is a small pull out tab below the off button. Give it 10 seconds or so and push it back in.

    If that doesn't work. You may need to reset back to factory defaults. This will unpair the device and reset trim levels.
    Triple tap (very fast) and hold the on button until the lights flash.
    Release and triple tap again within 1/2 second.
    LED, Incorporated
    Raleigh, NC 27614

  3. #3
    Junior Member
    Join Date
    Feb 2018
    Posts
    2
    Randyc, pulling out the gap switch for 10 seconds fixed the problem. Thank you!

  4. Likes randyc liked this post

Similar Threads

  1. Pair 4 button wireless remote to Caseta In-Wall Dimmer?
    By tomkk in forum General Discussion - CAS
    Replies: 9
    Last Post: 11-12-2017, 01:51 AM
  2. Caseta In-Wall Switch requires neutral but In-Wall Dimmer doesn't?
    By ccoulson in forum General Discussion - CAS
    Replies: 5
    Last Post: 09-27-2017, 10:00 AM
  3. Event scheduling does not respond
    By JoseSD in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 02-11-2017, 12:23 PM
  4. Use In wall dimmer as additional remote?
    By Davismeissner in forum Design Assistance - CAS
    Replies: 1
    Last Post: 12-03-2016, 09:09 PM
  5. Pico Remote Direct Wall Mount
    By kblaw in forum General Discussion - CAS
    Replies: 3
    Last Post: 11-07-2015, 03:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •