Low end trim and LED Tape issues with LTE 2 wire Hi-lume driver

[dvpvic]

Anyone have experience with running diodeled or flexfire led tape from the Hi-lume 2 wire constant voltage drivers? I got two units loaded at about 20w per driver controlled via a Graik Eye QS all settings setup in Ra2 software etc but im having issue with the leds flickering and eventually going out on low end. I can set the low trim higher but that's not the fix im looking for.

[Julia K.]

Hello dvpvic,

Thank you for your post!

The driver is programmed for 1%, you do not need to set this in the RA2 software. In the software you have to set the load type to Hi-Lume 1% 2-wire LTE LED and it will automatically set the high and low end trim to get the 100 to 1% dimming range. If you manually change the low end you can under drive the Driver which would explain the flickering and drop outs you are experiencing.

Please see the LTE spec sheet below for more information:
http://www.lutron.com/TechnicalDocum...369543_ENG.pdf

Hope this helps!

Julia K.